board cleats along the side panels to cut the span in half.
Dry fit of rear coamings and supports.
Getting there!
Front deck dry fit
Starting to look like a boat with all these pieces mocked up.
Gluing in the front coaming supports. They were far down the side panel so I had to get creative with the clamping.
Back coamings glued up with cleats in place
Glueing the rear most deck segment and supports for the next piece. Using my old world clamping method to weigh it all down.
Rear deck segments all dry fit and mocked up with hatch lids for dry fit
Dry fit mostly complete. Just a little more assembly to go.
Since it's so cold I need to get creative with the temperature control. I can only keep the kerosene heater going for so long before it starts getting expensive so I use it to heat while I work, then use cardboard and plastic to make a little make shift hot box over my area with a space heater inside